What exactly is the difference between a surge protector and a fuse? Can a fuse protect the electronic devices from lightning instead of surge protector?
12.06.2025 12:54

“ … to protect building, lightning arrestor, is provided above building and directly connected to earth.”
This is where this question deviates from being a 'generic' question, and becomes more specific.
He then describes Rainy Season and Lightning.
Why do I feel worthless most of the time?
These are simplified answers to the original question, and does not change anything I wrote above.
There are three different concepts here that are getting confused.
Now when you have a certain ac resistance, then a current flows in a loop.
Why is Tiananmen Square censored?
But it can get overloaded, and no longer works.
“ A fuse is a device which protects the (circuit) against overload and short circuit.”
Mohan forgets that a fuse is a one-time device, and needs to be replaced if it is tripped.
What's the most sordid activity you've ever seen or heard about at a bachelorette party?
“ A surge suppressor is the one which is connected at the input supply so that when there is a sudden change voltage it bypasses thereby protecting the (circuit) and electronic components”
but this device (an Inductor) … impedes the rapid changes in the current.
A fuse is a non-resetable over current circuit protector.
A circuit breaker is similar, but is resettable.
It also is a device that limits the change in current flow.
This is where the MOV conducts again, and dissipated the energy.
What kind of book did you write after turning 55?
But during the surge, the fuse will not blow if it is a longer duration and lower value )10 to 50%).
It’s been three xxx five werks, and there has been no response to my follow on query on his Commment to my answer.
The third is lightning and “how it gets conducted into a home.”
An AC voltage/ current source, and an ac inductive load.
There are two important concepts here.
First Sentence:
Why don't people like Nickelback?
2024–10–11 [Victor Olarewsju Victor Olarewaju ]
One
Fuses, on their own, then operate much slower than the MOV variable resistance, during the lightning strike.
Blue Origin performs 12th crewed New Shepard suborbital flight - SpaceNews
So combined with a device called a MOV or Metal-oxide-resistor, then forms the 3rd part of a “surge suppressor “.
At the secondary, it is 1000 times less.)turns ratio). If it gets hit with a 100,000 volt bolt of lightning then the voltage arrestors conduct and clamp the voltage down to line voltage, ( but a small amount leaks down the line). This is the problem.
OK, this is Mohan Rajaratnam’s definition of a Surge suppressor.
the problem then depends on "how fast does the fuse operate?".
So, it’s possible that these devices from Trip Lite have addition suppression devices, these ones seem to be sturdy.
2024–10–16 [ OO OLAOYE OYEBODE ]
This one hit behind the barn.
In schematic diagrams this is the symbol for a fuse:
This is 'the assistant's answer'
How good is KIIT school of management at Bhubaneswar?
This is a photo where a lightning bolt took out a home's complete mains distribution box, and a lot of electronic gear as well.
So, the voltage could go up to 500 volts, and the fuse will not open up.
(Dc diagram shown, AC is similar).
Phase-resolved attoclock precisely measures electron tunneling time - Phys.org
Edit 2024–10.
2024–10–11 [Bobby Sanchez Bobby Sanchez ].
so, what happens?
How did Nickelback gain a large fan base despite criticism of their music?
what exactly is a ‘surge’ protector?
He then asserts :
He then describes the function of a fuse.
Menopause Drug Reduces Breast Cancer Growth In Clinical Trial - ScienceAlert
This is the picture of an electronic coil of wire wound around a core of magnetic material.
Upvotes:
The other is “what does a “fuse” do?”
[image of Common-mode choke]
Here is a simplified AC power diagram.
One is “what exactly is in a ‘surge protector’ ? ”
When the current is 200% of the rated value , it will “go open” (the link metal melts) and protect the device.
The MOV will conduct when the voltage exceeds 50% of line voltage.
Once the voltage goes over 0.0650 volts, then this fact can be used to amplify the difference, and turn the circuit breaker off , furthur down the line. Essentially that is what a RCD/GFCI does, it compares the incoming current, to the outgoing current, and if the difference between the two currents is over 5mA, then it trips the circuit breaker.
The bolt then partially travels down the line to your home.
a photo is worth a thousand words.
2024–10–00 [ Ammar Mahdi ] Ammar Mahdi
Can the fuse protect the electronic devices from lightning instead of a surge protector.
[old diagram got deleted by accident]
At one ohm, the resistor has a maximum of 1 watt power.
2024–10–10[John johnson John Johnson ]
2024–09–27 [ Mohan Rajaratnam Mohan Rajaratnam ] . Thinks you can get free electricity from nothing : Mohan Rajaratnam's answer to Is it possible to generate free electricity at home using a magnet or other low-cost methods? If so, how does it work?
I post the exact comment here.
Is the question then , "why buy a surge supressor, if the fuse alone protects the electronic circuits from a lightning bolt?".
Would individual surge supressors have save this equipment? most likely, since the surge supressor would take the jolt instead of the electronic components.
Lightning arrestor is a spark-gap device, and can be installed anywhere. What is important, is that the wire is thick enough to withstand the lightning bolt and conduct the energy away from the building.
This is an electronic circuit designed to clamp voltages so that the Voltage Potential that appears at the outlet is never going to exceed the nominal value.
These devices are installed between the “hot” and “neutral” and protective ground.
so, the loop of wire then, when put together with another loop reduces the ‘noise’ on a power line.
And this is the problem alone. Is the power supply in the equipmemt designed with a lightning strike in mind? Some yes, others, no.
Barnstars:
What is lightning?
P = e* I, so since I is 16 amps, then the voltage dropped is 1/16 volt or 0.0650 volts.
For this case there are devices called Metal oxide varistors (MOV).
It seems Mohan does not understand the difference between a comment and an Answer.
If the nominal power is 4,000 watts then the current at 230volts is 16 amps.
(There is no concept of polarity, in the loop because the current changes direction 100 to 120 times a second (power frequency).
Because the load is inductive, the current lags the voltage.(by a bit).
What does a fuse do?
But… the neutral is now “floating” because of the 1 ohm resistance.
This device then solves the entire problem.
but I think this circuit , shows a few more pieces.
eight
At least they know the answer if they wanted it.
nine
This is a high voltage low current spike that comes down the line because of the power poles being struck, and the voltage suppressors activating on the primary side of the transformer.
2024–10–14 [Omar Gharbi Omar Gharbi ]
There is no harm in having the surge suppressor along with the fuse in the circuit. The fuse will not open up until the current melts the link. This will take time, and in the interim, that jolt will get transmitted into the power supplies.